Height-Stroke Count Index

You are here: Members Knowledge Base Height-Stroke Count Index

  • Author
  • #2607


    These charts will help you estimate your general Stroke Count, or in technical terms, your Strokes-Per-Length (SPL) range.

    This chart is for SPL in a 25 meter pool, assuming you take a 5 meter from push-off to first stroke.

    Height SPL graph 25mD

    This chart is for SPL in a 25 yard pool, assuming you take a 5 yards from push-off to first stroke.

    Height SPL graph 25yD

    This chart is for SPL in a 50 meter pool, assuming you take a 5 meter from push-off to first stroke.

    Height SPL graph 50mD


    In practices listed here on the TI Academy, when we refer to SPL, we will use terms like N, N-1, N+1, etc.

    N = the lowest number in your appropriate SPL Range. It’s not the lowest SPL you can possibly achieve, but the lowest within the range of appropriate SPL for your continuous swimming – in that range that is good for your energy use and shoulder health.

    If you have an SPL Range of 16 to 19, then your N = 16, N+1 = 17, N+2 = 18, N-1 = 15, etc.


    Based on a great deal of observation and comparison of data we see a strong case for setting a swimmer’s SPL range between 55% and 70% of their wingspan. The minimum SPL on this chart corresponds to 55% of height and the maximum corresponds to 70%. We chose to use height for these charts because most people know immediately what their height is, and for estimation purposes, that is close enough.

    Wingspan is the measurement of your arms spread wide, measured from finger tip to finger tip. Wingspan provides the more accurate estimate of what your stroke length potential is. In humans height is approximately the same as wingspan, within +/- 5% margin of difference. We see this difference between height and wingspan also matters but we’ll save that discussion for another article.


    So if you want to do the math to get more precise, personalized SPL for yourself you need this data:

    Your wingspan (W)

    Your pool length (PL)

    The distance of your glide to stroke #1 (DG)

    Then we start the calculations working with Stroke Length (SL).

    Calculate your minimum 55% SL:

    W x .55 = min SL

    Calculate your maximum 70% SL:

    W x .70 = max SL

    Then we convert to SPL which is dependent on your pool length and glide:

    Calculate your minimum SPL:

    (PL – DG) / max SL = min SPL

    Calculate your maximum SPL:

    (PL – DG) / min SL = max SPL

    Some things to keep in mind as you use Stroke Counting:


    How far you glide after pushing off from the wall to your first stroke affects your stroke count. If you followed the math calculations above you’ll notice that a short push-off will require you to take an extra stroke or two to reach the far wall, while a long one will allow you to take one or two strokes less.

    Work on keeping this push-off and glide distance consistent on every lap. If you have a long glide (5-6 meters) you can aim for a lower end of your SPL range. If you have a shorter glide (3-4 meters) you can aim for the higher end of your SPL range. 4-5 meter push-off to glide is a good average to aim for.


    This chart estimates a range of about 5 SPL counts. However, through testing and practice we recommend that you narrow your personal range down to 3 SPL counts.

    For example, for a male swimmer about 40 years old, 180 cm tall, the chart above suggests a 16-20 SPL in a 25 meter pool. If he has highly developed streamline and stroke efficiency he may aim for 16-18 SPL as his target SPL range. If less developed he may aim for 18-20 SPL.


    They function a bit like multiple gears on your bicycle, allowing you to adjust the pressure and frequency to use energy just the way you need to for a particular event or conditions.

    Your higher SPL count is generally for shorter distance, higher tempo, or lighter pressure strokes.

    Your lower SPL count is generally for longer distances, lower tempo, or higher (steady) pressure strokes.

    You may check out the thread ‘How To Count Strokes’ for more information.

    You must be logged in to view attached files.

    ~ Mediterra Admin

You must be logged in to reply to this topic.